Use the CLI commands in this topic to check your installed security content version.
To check installed security content version:
Go to CLI configuration mode:
hostname > enable hostname # configure terminal
Check the current security content status using the command below:
hostname (config) # show fenet security-content status
Check the Security Content Updates section in the DTI Security Content Status Information list, as shown in the example below:
Security Content Updates
Enabled : yes
Update mode : online
Last Checked At : 2020/01/07 00:44:00
Last Applied At : 2020/01/06 23:45:19
Last Applied Type : full
Timestamp (UTC) : 2020-01-06 23:15:00
Status : apply-info: No new security updates available
Security Content Version: 976.292
To check the Security Content versions and date they were installed:
Show log files containing security content information:
hostname (config) # show log files all matching "security content version is"
The output will look similar to the example below. You can see when a specific Security Content version was available by the earliest timestamp. The later timestamp shows when it was applied to your appliance.
Searching log files...
Mar 1 09:38:17 notifyd[18001]: [notifyd.NOTICE]-security content version is:249.101
Mar 1 14:19:01 notifyd[12385]: [notifyd.NOTICE]-security content version is:249.101
Mar 14 08:00:00 notifyd[4351]: [notifyd.NOTICE]-security content version is:252.101
Mar 14 10:15:42 notifyd[10820]: [notifyd.NOTICE]-security content version is:252.101