--- title: "Configuring domain and next-hop settings" slug: "configuring-domain-and-next-hop-settings" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Network Security"] updated: 2026-08-21T15:37:41Z published: 2026-08-24T18:57:06Z canonical: "docs.trellix.com/configuring-domain-and-next-hop-settings" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring domain and next-hop settings The Email Security — Server appliance uses a domain name and next-hop address to locate the destination mail server. The domain and next-hop address are required in the following analysis modes: - **Block** mode, to forward emails to the intended recipients, and to send "block," "admin," and "bcc" notices, if configured. - **Monitor** mode, to forward emails to the intended recipients, and to send "admin" and "bcc" notices, if configured. - **Tap/Span** mode, to send "admin" and "bcc" notices, if configured. - **Drop** mode, to send "admin" and "bcc" notices, if configured. Emails destined for the configured domain will be forwarded to the configured next-hop. The next-hop is the final mailbox host (where the recipients' mailboxes are located), and must be a fully qualified domain name. For example, the domain and next-hop could be configured as "acme.com" and "mail.acme.com." When load balancing multiple appliances, configure each appliance to use the same next-hop address. In addition, you can configure multiple next-hops to load balance next-hop addresses. > [!WARNING] > Important > > Make sure emails will not be looped back to the Email Security — Server appliance. > [!NOTE] > Note > > For details about load balancing, see [Load Balancing Email Traffic](/data-and-email/docs/load-balancing-email-traffic) . **Prerequisites** - Operator or Admin