--- title: "Configuring the Analysis Mode Using the CLI" slug: "configuring-the-analysis-mode-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-08-24T19:53:17Z published: 2026-08-24T19:53:17Z canonical: "docs.trellix.com/configuring-the-analysis-mode-using-the-cli" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring the Analysis Mode Using the CLI Use the CLI commands in this procedure to configure the relevant analysis mode. > [!WARNING] > Important > > After you change an analysis mode, use the **reload** command to reboot the appliance. **To configure the analysis mode:** ``` hostname > enable hostname # configure terminal ``` hostname (config) # **write memory** hostname (config) # **reload** 1. Enable the CLI configuration mode. 2. Specify the analysis mode. - To set the analysis mode to Block: `hostname (config) # email-analysis mode block` - To set the analysis mode to Drop: `hostname (config) # email-analysis mode drop` - To set the analysis mode to Monitor: `hostname (config) # email-analysis mode monitor` - To set the analysis mode to Tap/Span: `hostname (config) # email-analysis mode tap` 3. Save your changes. 4. Reboot the appliance. ### Example This example changes the analysis mode to monitor. ``` hostname (config) # email-analysis mode monitor You must reload the appliance for the analysis mode change to take effect. hostname (config) # show email-analysis Email-Analysis:  enabled:                   yes  mode:                      monitor  interface:                 pether3  ... hostname (config) # reload ```