--- title: "Creating a public key using the CLI" slug: "creating-a-public-key-using-the-cli" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Network Security"] updated: 2026-08-24T18:56:48Z published: 2026-08-24T18:56:48Z canonical: "docs.trellix.com/creating-a-public-key-using-the-cli" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Creating a public key using the CLI Use the commands in this section to create a new public key for SSH user authentication. You can use this key instead of the password to authenticate the remote user. **To create a public key:** 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Create the public key: ``` hostname (config) # cmc auth identity generate ``` where `<keyType>` can be `ssh-dsa2` or `ssh-rsa2` and `<identityName>` is a user-friendly name. 3. Verify your changes: ``` hostname (config) # show cmc auth identities ``` 4. Save your changes: ``` hostname (config) # write memory ``` **To remove a public key:** 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Remove the public key: ``` hostname (config) # no cmc auth identity ``` 3. Verify your change: ``` hostname (config) # show cmc auth identities ``` 4. Save your changes: ``` hostname (config) # write memory ``` ### Example The following example creates an SSH-DSA2 identity named "admin4" on the NX-04 appliance. ``` NX-04 (config) # cmc auth ssh-dsa2 identity admin4 NX-04 (config) # show cmc auth identities DSA2 identity admin4:   Public Key: ssh-dss AAA3NzaC1kc3MAAACBAJl3PisWNnz/gYLvL4JC7xFMoq3HE89rai7trnJmpxjylArYhf MzaGndFA4qGRZMFzhiz9Jhi/+W1ufIrXLGzakC0lAAAAFQCuMCsMwMGN9zT5w2JCiDt7D6orNwAA ... ``` > [!NOTE] > Note > > This example is from a Network Security appliance, but it is representative of other Trellix appliances as well.