Use the CLI commands to globally enable or disable the Trellix Riskware rules on the appliance.
![]() | Riskware detection for Trellix Riskware rules are enabled by default. |
To globally enable the Trellix Riskware rules for alerts:
Go to CLI configuration mode.
hostname > enable hostname # configure terminal
Enable the Trellix Riskware rules on the appliance.
hostname (config) # analysis riskware policy fe-rules enable
hostname (config) # write memory
Save your changes.
To globally disable the Trellix Riskware rules for alerts:
Go to CLI configuration mode.
hostname > enable hostname # configure terminal
Disable Trellix riskware rules on the appliance.
The following message is displayed:
hostname (config) # no analysis riskware policy fe-rules enable
% The rules are now disabled.Trellix recommends re-enabling these rules for security reasons.Save your changes.
hostname (config) # write memory
.png?sv=2026-02-06&spr=https&st=2026-11-22T14%3A09%3A06Z&se=2026-11-22T14%3A20%3A06Z&sr=c&sp=r&sig=4rp6jBOT4tT1RYOeCiGG3ut0lRDHiTI2F3frhPLvRp0%3D)