Use the commands in this topic to manually mount or unmount a USB device to the attached appliance. Trellix recommends that you physically remove the USB device from the port. Use the media usb mount command before you attach the drive, and use the media usb eject command after you unplug it.
Note
The
media usb ejectcommand will have no effect if the USB device is not mounted.
Prerequisites
Admin access
To mount a USB device:
Go to CLI configuration mode:
hostname > enable hostname # configure terminal
Mount the USB device to the attached appliance:
hostname (config) # media usb mount
To unmount a USB device:
Go to CLI configuration mode:
hostname > enable hostname # configure terminal
Unmount the USB device from the attached appliance:
hostname (config) # media usb eject