--- title: "Perform system recovery using the Data Protection Self Service Portal" slug: "perform-system-recovery-using-the-data-protection-self-service-portal" updated: 2026-09-12T17:36:46Z published: 2026-09-12T18:56:01Z canonical: "docs.trellix.com/perform-system-recovery-using-the-data-protection-self-service-portal" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Perform system recovery using the Data Protection Self Service Portal This section describes the installation, configuration, and operation of the Data Protection Self Service Portal (DPSSP), which can be used with DE to allow users to obtain the recovery key or response code for a Drive Encryption system. **Important: Privacy Notice** DPSSP collects users' login names, system names, IP addresses, and audit data. Access to this information is available in DPSSP reports within ePO - On-prem. Ensure that access to these reports is authorized and appropriately managed. The administrator must first install the `dpssp.zip` extension in ePO - On-prem, and make the required DPSSP server settings. An authorized client user can open the DPSSP portal on a system to obtain a response code for Drive Encryption upon entering the corresponding challenge code for the system to be recovered. The full DPSSP URL in displayed in Menu → Configuration → Server Settings → DPSSP Settings. The DPSSP URL will be of the general form **https://:/dpssp/selfRecovery**. ### Important The default port number used in the DPSSP URL is **8443**. To review an issue where using Port 8444 causes a problem with the website's security certificate when accessing DPSSP, see [KB86781](https://thrive.trellix.com/s/article/KB86781). :