--- title: "Prerequisites to use Drive Encryption in FIPS mode" slug: "prerequisites-to-use-drive-encryption-in-fips-mode" tags: ["Drive Encryption", "Install and Get Started"] updated: 2026-09-12T16:52:02Z published: 2026-09-12T16:52:02Z canonical: "docs.trellix.com/prerequisites-to-use-drive-encryption-in-fips-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Prerequisites to use Drive Encryption in FIPS mode For Drive Encryption 8.x or later to be in compliance with FIPS 140-2, the software must meet these conditions. - The Drive Encryption client package must be installed on the client in FIPS mode. - Depending on compliance requirements mandated by your auditor (with particular regard to key generation), you might also need to install ePO - On-prem in FIPs mode. For more information, refer to the Knowledge Base article [KB83483](https://thrive.trellix.com/s/article/KB83483). If you don't install both ePO - On-prem and Drive Encryption in FIPS mode, the configuration does not operate in a FIPS-certified manner. ### Important Drive Encryption must be operating in FIPS mode at the time of activation of a client to ensure that keys are generated in a FIPS-approved manner. Upgrading an active Drive Encryption client to a FIPS mode version of Drive Encryption 8.x or later does not imply that the client is now running with FIPS quality keys. A Drive Encryption active client should be decrypted, deactivated, and then reactivated using a FIPS mode client installation in order to be FIPS-compliant. :