--- title: "Restricting MTA access" slug: "restricting-mta-access-1" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-08-22T16:18:38Z published: 2026-08-24T19:53:24Z canonical: "docs.trellix.com/restricting-mta-access-1" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Restricting MTA access You can allow only certain devices to connect and transmit emails to the Email Security - Server appliance. Configure a single IP address or multiple IP addresses in the MTA access restriction list by using the Email Security - Server appliance CLI: - [Restricting MTA access with a single IP address using the CLI](/data-and-email/docs/restricting-mta-access-with-a-single-ip-address-using-the-cli) - [Restricting MTA access with multiple IP addresses using the CLI](/data-and-email/docs/restricting-mta-access-with-multiple-ip-addresses-using-the-cli) You can specify up to ten IP addresses in the list. Both IPv4 and IPv6 addresses are supported. Separate addresses with a space. The Email Security - Server appliance checks each address for the proper syntax but does not validate the syntax. Trellix recommends that you validate the address or addresses before and after a change is made. By default, there is no access restriction to the MTA interface. You must telnet to your Email Security - Server appliance from the upstream MTA to verify that the configuration is correct. ### Prerequisites - Administrator or Operator access to the Email Security - Server appliance. - An established connection between the Email Security - Server appliance and the Internet. - Enable IPv6 on the Email Security - Server appliance. For details about how to enable IPv6 routing, refer to the "Basic Network Configuration" chapter of the System Administration Guide. - Enable IPv6 on the SMTP interface if you want to configure one static IPv6 address. For details, refer to the "Basic Network Configuration" chapter Email Security - Server System Administration Guide. - Configure the SMTP (pether3) interface with an IP address and mask length. For details, see [Configuring the SMTP interface with an IP address using the Web UI](/data-and-email/docs/configuring-the-smtp-interface-with-an-ip-address-using-the-web-ui) or [Configuring the SMTP interface with an IP Address using the CLI](/data-and-email/docs/configuring-the-smtp-interface-with-an-ip-address-using-the-cli).