--- title: "Restricting MTA access with a single IP address using the CLI" slug: "restricting-mta-access-with-a-single-ip-address-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-08-24T19:53:10Z published: 2026-08-24T19:53:10Z canonical: "docs.trellix.com/restricting-mta-access-with-a-single-ip-address-using-the-cli" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Restricting MTA access with a single IP address using the CLI Use the CLI commands in this topic to configure the MTA access restriction with a single IP address. **To configure the MTA access restriction with a single IP address:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Specify a single IP address for the MTA access restriction. The following example command restricts all MTA hosts except the specified IPv4 address in Drop analysis mode: ``` hostname (config) # email-analysis mta mynetworks 172.16.183.3 ``` `MODE is drop` The following example command restricts all MTA hosts except the specified IPv6 address in Drop analysis mode: `hostname (config) # email-analysis mta mynetworks 2001:470:84a7:3066::aa0` `MODE is drop` `IPv6 enabled` 3. Verify your changes. `hostname (config) # show email-analysis mta mynetworks` > [!NOTE] > Note > > The internal loopback address is not displayed in the `show email-analysis mta mynetworks` command output. Only values that you entered are displayed. 4. Save your changes. ``` hostname (config) # write memory ``` ### Examples This example shows that all MTA hosts are restricted except the specified IPv4 address. `hostname (config) # show email-analysis mta mynetworks` `172.16.183.3` This example shows that all MTA hosts are restricted except the specified IPv6 address. `hostname (config) # show email-analysis mta mynetworks` `[2001:470:84a7:3066::aa0]`