--- title: "Set up a cluster of Trellix DLP Network Prevent appliances" slug: "set-up-a-cluster-of-trellix-dlp-network-prevent-appliances-1" tags: ["Product Usage", "DLP 11.14.x"] updated: 2026-09-01T07:29:22Z published: 2026-09-01T07:29:22Z canonical: "docs.trellix.com/set-up-a-cluster-of-trellix-dlp-network-prevent-appliances-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Set up a cluster of Trellix DLP Network Prevent appliances To load balance incoming traffic and ensure high availability, you can create clusters of Trellix DLP Network Prevent appliances. Configure two or more Trellix DLP Network Prevent appliances with LAN 1 connected to the same network segment. All appliances in a cluster must be in the same subnet or network. 1. In ePO - On-prem, open the **Policy Catalog**. 2. Select the **DLP Appliance Management** product, choose the **General** category, and open the policy that you want to edit. 3. In **Load Balancing**, select **Enable**. 4. In **Cluster ID**, use the arrows to select a number to identify the cluster. 5. In **Virtual IP**, enter a virtual IP address so that packets for the virtual IP address are sent to the cluster primary appliance. The appliances in the cluster use the netmask assigned to the physical IP address. The virtual IP address must be in the same subnet or network as the other Trellix DLP Network Prevent appliances, and cannot be the same IP address as any other appliance in the cluster. 6. Click **Save**. ePO - On-prem pushes the configuration to all appliances in the cluster when you apply the changes. It takes about five minutes for the cluster to stabilize and identify the cluster primary appliance and cluster scanners. The appliance descriptions then change accordingly in **Appliance Management**.