--- title: "Check for IPv6 compatibility" slug: "check-for-ipv6-compatibility" tags: ["ESM"] updated: 2026-09-12T21:25:04Z published: 2026-09-12T21:25:04Z canonical: "docs.trellix.com/check-for-ipv6-compatibility" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Check for IPv6 compatibility To check for IPv6 compatibility, complete the following 1. To allow read and write permissions on the mounted file systems, in NFS server update the `/etc/exports` file with the ELM and ELS IP addresses. For example: ```plaintext entry /etc/exports -alldirs -quiet -maproot="siem":"nogroup" -network \ /mnt/tankA/nfs-testing -alldirs -quiet -maproot="siem":"nogroup" -network 2607:8d40:42:3501:1111:ffff:ffff:1122/64 ``` Replace `<mount_point>` and `<IP address of ELM/ELS/subnet>` with appropriate values. 2. Ensure NFS server reads the updated file. For example, on a Ubuntu system, use the following command: ```plaintext exportfs -ra ``` > ### Note > > This command is specific to Ubuntu. If you use a different operating system, use the command appropriate to your OS. 3. Update the settings in the `/etc/NitroGuard/network.conf` file: - To assign a static IPv6 address, make the following changes: - ipv6=manual - dhcp=no - Enter appropriate values for gateway, dns1, and dsn2. - To configure a DHCP assignment for the IPv6 address, make the following changes: - ipv6=manual - dhcp=yes > ### Note > > There should not be any line for IPv4 in the network.conf file. > > Only ipv6=manual is supported. > > ipv6=off refers to an IPv4 environment, whether DHCP is set to yes or no. 4. Enable the Rule Service connection. In the UI, go to System Properties → Clustering → Edit the Node → Proxy and enter the IPv6 address of the proxy server, port, and credentials. 5. Check the rule service is connected. In the UI, go to System Properties → System Information → Rules Update → Credentials → Customer ID and Password. :