--- title: "Configure a SAN storage device" slug: "configure-a-san-storage-device" tags: ["ESM", "Install and Get Started"] updated: 2026-09-12T21:29:45Z published: 2026-09-12T21:29:45Z canonical: "docs.trellix.com/configure-a-san-storage-device" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure a SAN storage device Add a SAN card to increase data storage capacity. Install the SAN card. 1. On the system navigation tree, select **ELM Properties**, then click **Data Storage**. 2. Click the **SAN** tab, then check the status of the SAN volumes that were detected. - **Format required** — volume must be formatted and doesn't appear on the list of available volumes on the **Add Storage Device** page. - **Formatting** — volume is in the process of being formatted and doesn't appear on the list of available volumes. - **Ready** — volume is formatted and has a recognizable file system. These volumes can be used to store ELM data. 3. If a volume is not formatted and you want it to store data, click it, then click **Format**. > ### Important > > Formatting a volume deletes all stored data. 4. To check if formatting is complete, click **Refresh**. When formatting completes, the system changes the status to **Ready**. 5. To view the details of a volume at the bottom of the page, click the volume. :