--- title: "Configure Cisco IOS" slug: "configure-cisco-ios" tags: ["ESM", "Reference"] updated: 2026-10-27T15:50:12Z published: 2026-10-27T15:50:12Z canonical: "docs.trellix.com/configure-cisco-ios" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure Cisco IOS 1. Open a secure connection to the console of your Cisco IOS device, then go into enable mode. ``` Router> enable ``` ### Note Depending on your configuration, you might need to enter a password. 2. Once in enable mode, go into global configuration mode. ``` Router# configure terminal Router(config)# ``` 3. Enable the syslog message. ### Note System messages are enabled by default. If logging is disabled, use this command to enable it or to ensure that it is on. ``` Router(config)# logging on ``` By default, this only logs to the console. Use this command to enable logging to send to a specific host, such as the Trellix Event Receiver. The host argument is the name or IP address of the host. ``` Router(config)# logging ``` 4. Enable time stamps for logs. ``` Router(config)# service timestamps log datetime localtime Router(config)# service timestamps debug datetime localtime ``` 5. Adjust the security level with this command. ``` Router(config)# logging trap ``` | Emergency | 0 | System unusable messages | | --- | --- | --- | | Alert | 1 | Immediate action required messages | | Critical | 2 | Critical condition messages | | Error | 3 | Error condition messages | | Warning | 4 | Warning condition messages | | Notification | 5 | Normal but significant messages | | Information | 6 | Informational messages | 6. Save changes and exit: 7. Close out of config mode. ``` Router(config)# exit ``` 8. Save changes. ``` Router# copy running-config startup-config ``` Or: ``` Router# copy run start ``` 9. Exit from enable mode. ``` Router# disable Router> ``` :