--- title: "Configure data sources" slug: "configure-data-sources" tags: ["ESM", "Install and Get Started"] updated: 2026-09-12T21:29:45Z published: 2026-09-12T21:29:45Z canonical: "docs.trellix.com/configure-data-sources" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure data sources Data sources represent the assets connected to your network. An asset is any device with an IP address. Receivers collect event logs from data sources and then parse the logs and send them to storage. Add data sources and define their settings so they collect the data you need. - Make sure that the Trellix Enterprise Security Manager - Event Receiver for this data source is listed on the system navigation tree. - Make sure that the data source is configured to send logs to a Receiver. See the [Data Source Configuration Reference](https://docs.trellix.com/bundle/enterprise-security-manager-data-source-configuration-guide/). If you have issues while configuring a data source, run the Data Source Health Check Parser Properties → Health and see the Troubleshooting section of the [Data Source Configuration Reference](https://docs.trellix.com/bundle/enterprise-security-manager-data-source-configuration-guide/). 1. From the Trellix ESM dashboard, click and select More Settings . 2. On the **Receiver Properties** page, click **Data Sources**. 9E5mPA table lists existing data sources (including child and client data sources) and identifies how the data source processes data. > ### Note > > If **SNMP Trap** is selected, the data source accepts standard SNMP traps from any manageable network device with the capability of sending SNMP traps. When Trellix ESM receives these traps, it generates an event for the data source. To send or receive SNMP traps via IPv6, formulate the IPv6 address as an IPv4 conversion address. 3. Do one of the following: - To add a new data source, click **Add**. - To add a child data source to an existing data source, click **Add Child**. - To edit an existing data source, select the data source then click **Edit**. 4. Configure the data source. 1. To pre-populate SNMP and syslog protocol-based devices, click **Use System Profiles** 2. Enter a **Data Source Vendor** and **Data Source Model**. These determine what information you enter for the data source. Advanced syslog parser (ASP) data sources that generate data without UTF-8 encoding, select **Generic** as the vendor and **Advanced Syslog Parser** as the model. 3. Select a **Data Format** to set the parsing method. 4. Select a **Data Retrieval** method. - For **SCP**, set the LANG environment variable to **lang=C**. - **SCP File Source** does not support relative paths. Define the full location. - For **CIFS File Source** or **NFS File Source**, select a collection method. 5. Enable the method the Trellix Enterprise Security Manager - Event Receiver uses to process data. 6. Complete additional fields based on vendor, device model, data retrieval method, or protocol of the device. The data sources appear under the Trellix Enterprise Security Manager - Event Receiver on the navigation tree. :