Configure Nortel Networks Passport 8000 Series Switches

Prev Next

This syslog configuration is done at the command line. See your product documentation for instructions about how to access and use the command line.

  1. At the command line, enter this command:

    config sys syslog host <ID>

    where <ID> is the ID of the host that is sending syslog events. The ID can be a number from 1–10.

  2. Specify where to send syslog events:

    address <IP address>

    where <IP address> is the IP address of the Trellix Event Receiver.

  3. Specify the facility:

    host <ID> facility local0

    Replace <ID> with the ID used in Step 1.

  4. Enable the host:

    host enable
  5. Specify the severity level:

    host <ID> severity info

    Replace <ID> with the ID used in Step 1.

  6. Enable the host to send syslog events:

    state enable