Use the command line interface (CLI) to configure your IBM iSeries (or AS/400) system.
Log on to your IBM iSeries (or AS/400) system from the command line.
Type STRAUD and press Enter.
From the audit menu, select System | Configuration.
From the System Configuration Menu, select SYSLOG | Definitions.
Set the value of Send SYSLOG message to Yes.
Set the value of Destination address to the IP address of your Trellix Event Receiver.
Set the value of Facility to use to your preferred facility level.
Set the value of Severity range to auto send to your preferred severity range.
Save your changes.