Log on to the Symantec Message Gateway Control Center as administrator.
Navigate to Administration | Settings | Logs, then select the Remote tab.
Select Enable Syslogs for the following host, then select the host to send syslog data from.
In the Host field, enter the IP address of the Trellix Event Receiver.
Enter the port where the Trellix Event Receiver is listening (default is 514).
Set the Protocol field to UDP.
Set the Component Remote Log Levels to the level you want.
Select Enable Message Logs so that message logs are sent to the Trellix Event Receiver.
Set the Message log facility to the level you want.
Save changes.
Configure Symantec Messaging Gateway
- Published on Oct 27, 2026
- 1 minute(s) read
Was this article helpful?