--- title: "Configuring initial settings using the LCD panel" slug: "configuring-initial-settings-using-the-lcd-panel" tags: ["HX 10.x", "Endpoint Security (HX)", "Product Usage"] updated: 2026-09-10T21:18:41Z published: 2026-09-10T21:18:41Z canonical: "docs.trellix.com/configuring-initial-settings-using-the-lcd-panel" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring initial settings using the LCD panel An LCD panel is available on the front of some appliance models. It is not available on the HX 4000 appliance. To configure initial settings from the LCD panel: 1. Press the center button to access the **Network** menu and respond to the prompts: 1. **Hostname**—Specify the hostname for the system. 2. **DHCP enabled**—Enter **yes** to use dynamic host configuration protocol (DHCP). Enter **no** to manually configure your IP address and network settings. If you entered **yes**, proceed to the **IPv6 enabled** step. 3. **Static IP address**—Enter the IP address for the Ethernet 1 (management interface) port. 4. **Netmask**—Enter the network mask. 5. **Default gateway**—Enter the gateway IP address for the management interface. 6. **Primary DNS**—Enter the primary DNS server IP address. 7. **Domain name**—Enter the domain name for the management interface; for example, **it.acme.com**. 8. **IPv6 enabled**—Enter **yes** to enable IPv6 protocol, which changes network IP routing from IPv4 to IPv6. If you enter **no**, proceed to the **Admin net login** step. 9. **SLAAC enabled**—Enter **yes** to enable IPv6 autoconfig on the ether1 (management interface) port. . Enter **no** to disable IPv6 autoconfig on the ether1 (management) interface port. 10. **Admin net login**—Enter **yes** to enable the administrator to log in to the system remotely. Enter **no** to disable remote access. 2. Press the left or right arrow button until you reach the **LCD** menu. At the **Password** prompt, enter a password used to access the LCD panel. (This is not the password used to access the appliance Web UI or CLI.) 3. Press the left or right arrow button until you reach the **Config Options** menu. At the **Reset admin password** prompt: After the initial configuration, you can change to a password of your choice using the appliance Web UI or CLI. 1. Press the center button to reset the password used by the permanent admin user to log in to the appliance Web UI or CLI. (This is not the password used to access the LCD panel.) 2. A randomly generated password is displayed. After you memorize it, press the center or exit button to dismiss the display. :