--- title: "Configuring initial settings using the serial console port" slug: "configuring-initial-settings-using-the-serial-console-port-1" tags: ["Endpoint Security (HX)", "Product Usage"] updated: 2026-09-23T17:17:23Z published: 2026-09-23T17:25:27Z canonical: "docs.trellix.com/configuring-initial-settings-using-the-serial-console-port-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Configuring initial settings using the serial console port If you are not using a terminal server, you need to be physically near the Endpoint Security (HX) appliance to use the serial port. The serial port is on the back of the appliance. See your *Hardware Administration Guide* to view the port location. The serial port uses the following settings: - Baud rate: 115200 - Data bits: 8 - Stop bits: 1 - Parity: None - Flow control: XON/XOFF ### Note If the appliance stops responding on startup without displaying an error message, the serial port or the connection may be faulty. If this occurs, do the following: 1. Press and hold the power button on the front of the appliance for a few seconds until the appliance powers off. 2. Unplug all power cables from the server and wait for about 5 minutes to ensure shutdown is complete. 3. Connect a different serial cable. 4. Plug in the power cables. 5. If the server does not automatically restart, press the power button. Configure initial settings as described in the following topics: - [Using a Windows or Mac Laptop](/docs/using-a-windows-or-mac-laptop-1) - [Using a Linux System](/docs/using-a-linux-system-1) - [Using a Terminal Server](/docs/using-a-terminal-server-1) :