--- title: "Converting the on-premises appliance into a TCP relay" slug: "converting-the-on-premises-appliance-into-a-tcp-relay-2" tags: ["HX 10.x", "Endpoint Security (HX)", "Product Usage"] updated: 2026-09-10T17:52:14Z published: 2026-09-10T17:52:14Z canonical: "docs.trellix.com/converting-the-on-premises-appliance-into-a-tcp-relay-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Converting the on-premises appliance into a TCP relay To convert the on-premises Endpoint Security (HX) appliance into a TCP relay for the cloud Endpoint Security (HX) server using the CLI: 1. Log in to the on-premises Endpoint Security (HX) appliance using the SSH protocol and the IP address or host name of the appliance's management interface. 2. Enable CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 3. Convert the on-premises Endpoint Security (HX) appliance into a TCP relay to the cloud Endpoint Security (HX) server: ``` hostname # hx rproxy relay ``` where `<ip-address-or-host-name>` is the host name or public IP address for the cloud Endpoint Security (HX) ecosystem. You collected this information for the cloud Endpoint Security (HX) ecosystem before the on-premises Endpoint Security (HX) appliance backup was uploaded to the cloud Endpoint Security (HX) server. See [Recording the Server Address List Settings of the Cloud Endpoint Security Ecosystem](/docs/collecting-cloud-server-information-and-ca-certificates-2). 4. Save your changes: ``` hostname (config) # write memory ``` ### Note If the Endpoint Security (HX) appliance is in relay mode when it is upgraded, relay mode must be re-enabled after the upgrade completes. :