--- title: "Creating Endpoint Security (HX) network interfaces" slug: "creating-endpoint-security-hx-network-interfaces" tags: ["Endpoint Security (HX)", "Reference"] updated: 2026-09-10T17:16:26Z published: 2026-09-10T17:16:26Z canonical: "docs.trellix.com/creating-endpoint-security-hx-network-interfaces" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Creating Endpoint Security (HX) network interfaces The ether1 interface on the Endpoint Security (HX) virtual machine is the only interface that Azure creates by default. You must create the optional submission interface (ether2), and then attach the network interfaces to the virtual machine. IP forwarding must be enabled on monitoring interfaces to ensure that all network traffic reaches the Endpoint Security (HX) appliance. To create a network interface: 1. In the Azure portal, select **All services**, and then click **Network interfaces** under **Networking**. 2. Click **Add**. The **Create network interface** page opens. 3. Make sure the correct **Subscription** is selected. 4. Select the correct **Resource group**. 5. Enter a meaningful **Name** for the interface. 6. Make sure the correct **Region**, **Virtual network**, and **Subnet** are selected. ### Important Each interface must be in a separate subnet. 7. *Recommended*: Click **Static** and enter a static IP address to assign to the interface. Otherwise, select **Dynamic**. 8. Select the correct **Network security group**. 9. Select the **Private IP address (IPv6)** check box if the subnet uses IPv6 addresses. 10. Click **Next: Add tags** and specify name and value pairs for the tags to apply to the network interface. 11. Click **Review + create**. 12. Click **Create** after the validation passes and you confirm the information on the page. :