--- title: "Designating and enabling a DMZ server as a provisioning server" slug: "designating-and-enabling-a-dmz-server-as-a-provisioning-server-3" tags: ["HX 10.x", "Endpoint Security (HX)", "Product Usage"] updated: 2026-09-10T21:18:41Z published: 2026-09-10T21:18:41Z canonical: "docs.trellix.com/designating-and-enabling-a-dmz-server-as-a-provisioning-server-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Designating and enabling a DMZ server as a provisioning server When you use the Web UI to enable provisioning on your DMZ server, your Endpoint Security (HX) agents receive the new configuration setting but the provisioning server does not start on your DMZ server. To start the provisioning server on your DMZ server, you must also enable provisioning on your DMZ server through the CLI or provisioning will fail. **To designate a DMZ server as a provisioning server using the Web UI:** ### Note After you use the Web UI to designate the DMZ server as a provisioning server, you must also enable provisioning for the DMZ server in the CLI. 1. Log in to the Web UI for your DMZ server. 2. From the **Admin** menu, select **Agent Versions**. 3. In the upper right corner of the page, select **Assign Server Addresses** to go to the **Policies** page. 4. From the **Policies** table, click the **Agent Default policy** link. 5. Select the **Server Addresses** tab. 6. From the **Enable Provisioning** section, locate the DMZ server that you want to use for provisioning. 7. If the endpoints in your environment have agent software versions earlier than version 20 installed, select **Set as Primary** to designate the DMZ server as the provisioning server. This will deselect any other server on the Server Addresses tab as the primary server. If the endpoints in your environment have agent software version 20 or later installed, select **Enable Provisioning** to designate the DMZ server as a provisioning server. 8. Click **Save**. **To use the** **Endpoint Security (HX)** **server CLI to enable provisioning for a DMZ server:** 1. On your Endpoint Security (HX) appliance, enable CLI configuration mode. ``` hostname > enablehostname # configure terminal ``` 2. Enable provisioning on your DMZ server: ``` hostname (config) # hx ecosystem dmz provisioning-enabled ``` where `<dmz-ip>` is the IP address of the DMZ server for which you are enabling provisioning. 3. Save your changes. ``` hostname (config) # write memory ``` 4. Verify that the DMZ server is a provisioning appliance. ``` hostname (config) # show hx ecosystem ``` The server configuration should show an attached DMZ server with provisioning enabled: ``` Appliance Role: master DMZ Appliance: { or } Provisioning: enabled                     ``` :