--- title: "Install the software on an unmanaged system" slug: "install-the-software-on-an-unmanaged-system-2" tags: ["Install and Get Started", "ACC 6.6.x"] updated: 2026-08-31T19:06:24Z published: 2026-08-31T19:06:24Z canonical: "docs.trellix.com/install-the-software-on-an-unmanaged-system-2" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Install the software on an unmanaged system When you install in silent mode on an unmanaged system, no messages are displayed. Instead, a log file captures installation information, including whether the installation was successful. You can review the log file and determine the installation results. To install the software in silent mode, use the provided command-line options to suppress all interaction and provide parameters for all options. > [!NOTE] > Note > > For information about installing TACC on secure boot enabled Linux endpoints, see [KB96331](https://thrive.trellix.com/s/article/KB96331). 1. Log on to an unmanaged system as *root super user* (administrator rights). 2. Verify that the required installer is available. 3. Run the installer script: `./mapkg_install.sh` > [!NOTE] > Note > > Make sure the SELinux policy module is loaded on RHEL 8 and RHEL 9 endpoints. On RHEL 8 and RHEL 9 endpoints, run semodule -l | grep solidcore. The following message is displayed. `solidcore-insmod` For information about supported SELinux modes, see [KB91660](https://thrive.trellix.com/s/article/KB91660). 4. Add the purchased license: `sadmin license add xxxx-xxxx-xxxx-xxxx-xxxx` > [!NOTE] > Note > > For information about your license key, see [KB90666](https://thrive.trellix.com/s/article/KB90666). 5. If the purchased license is for Application Control: 1. Solidify the system: `sadmin so` 2. Enable the software: `sadmin enable` 3. Restart the Solidcore service: `service scsrvc restart` 6. If the purchased license is for Change Control: 1. Enable the software: `sadmin enable` 2. Restart the Solidcore service: `service scsrvc restart` 7. Verify that the Solidcore client is successfully installed and is in Enabled mode: `sadmin status`