--- title: "Installing a virtual server using VMware ESXi" slug: "installing-a-virtual-server-using-vmware-esxi" tags: ["HX 11.x", "Endpoint Security (HX)", "Product Usage"] updated: 2026-09-10T15:49:39Z published: 2026-09-10T15:49:39Z canonical: "docs.trellix.com/installing-a-virtual-server-using-vmware-esxi" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Installing a virtual server using VMware ESXi This section describes how to install a virtual server using VMware ESXi. Both Endpoint Security (HX) and DMZ servers can be virtual servers. ### Important This procedure uses VMware ESXi version 6.0.0 (build 3568940) and vSphere Client version 6.0.0 (build 3562874) on VMware vCenter Server version 6.0.0 (build 3018524). The navigation instructions and user interface may vary based on your version of these products. ### Note This procedure covers the required settings for a Trellix virtual server. You can accept the default values for the other settings, or specify values that are appropriate for your setup. To install a virtual server using VMware ESXi: 1. Log in to vSphere Client. 2. From the **File** menu, select **Deploy OVF Template** to start the wizard. 3. On the **Source** screen, click **Browse** and navigate to the OVA file containing the Endpoint Security (HX) or Central Management System Series system image. Then click **Next**. 4. On the **OVF Template Details** screen, review the information. If the information is correct, click **Next**. Otherwise, click **Back** and enter the correct URL or path. 5. On the **Name and Location** screen, enter a unique name that describes the virtual server. 6. On the **Disk Format** screen, click **Next**. 7. On the **Network Mapping** screen, click **Next** to accept the default settings. 8. On the **Properties** screen, you can complete fields to configure initial settings as described in [Specifying Initial Settings Using the VMware ESXi Properties Screen](/docs/specifying-initial-settings-using-the-vmware-esxi-properties-screen). (If you do not use this screen, you must type the values into the vSphere Client console manually, because you cannot paste into this console.) 9. On the **Ready to Complete** screen: 1. Verify the information. 2. (*Optional*) Select the **Power on after deployment** checkbox. 3. Click **Finish**. The server must be configured to set up its management interface, and to allow access to the network, change the default administrator password, and so on. For complete information, see [Initial Configuration of Virtual Servers](/docs/initial-configuration-of-virtual-servers). :