Installing licenses using the CLI

Use the CLI commands in this topic to install licenses on the HX appliance.

Prerequisites

Admin or Operator access

To install licenses:

Go to CLI configuration mode:

hostname > enable
hostname # configure terminal

Install each license:
```
hostname (config) # license install <key1> <key2> <key3>
```
Note
You can enter the license keys sequentially separated by spaces as shown above, or enter license install and then press Enter to be prompted to enter the license keys one at a time.

Verify the licenses:

hostname (config) # show licenses
License 1: LK2-FIREEYE_APPLIANCE-<license details>
    Feature:          FIREEYE_APPLIANCE
    Description:      FireEye Appliance Type
    Valid:            yes
    Start date:       2016/12/01 (ok)
    Tied to appl ID:  8699351EB1D5 (ok)
    Product:          HX (ok)
    Type:             PROD (ok)
    Tied to model:    FireEyeHXVM (ok)
    Agreement:        EULA (ok)
    Appliance role:   master
    Active:           yes

License 2: LK2-CONTENT_UPDATES-<license details>
    Feature:          CONTENT_UPDATES
    Description:      Content updates
    Valid:            yes
    Start date:       2016/12/01 (ok)
    End date:         2017/12/01 (ok)
    Tied to appl ID:  8699351EB1D5 (ok)
    Sharing:          all (ok)
    Active:           yes

License 3: LK2-FIREEYE_SUPPORT-<license details>
    Feature:          FIREEYE_SUPPORT
    Description:      FireEye support
    Valid:            yes
    Start date:       2016/12/01 (ok)
    End date:         2017/12/01 (ok)
    Tied to appl ID:  8699351EB1D5 (ok)
    Sharing:          all (ok)
    Active:           yes

...

Save your changes:
```
hostname (config) # write memory
```