--- title: "Re-enable relay mode after upgrading the server" slug: "re-enable-relay-mode-after-upgrading-the-server" tags: ["Endpoint Security (HX)", "Release Notes"] updated: 2026-09-10T17:18:54Z published: 2026-09-10T17:18:54Z canonical: "docs.trellix.com/re-enable-relay-mode-after-upgrading-the-server" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Re-enable relay mode after upgrading the server If the Endpoint Security (HX) server is in relay mode when it is upgraded, reenable relay mode after the upgrade. 1. Log in to the Endpoint Security (HX) server as an administrator. 2. Go to CLI configuration mode on the Endpoint Security (HX) server. hostname > `enable` hostname > `#configure terminal` 3. Review your relay mode settings before proceeding. hostname (config) `# show hx rproxy` 4. Reenable relay mode. hostname (config) `hx rproxy relay <hostname-or-IPaddress>` where is the host name or IP address of the Endpoint Security (HX). 5. Save your settings. hostname (config) `# write memory` :