--- title: "Retrieving SNMP data using event OIDs" slug: "retrieving-snmp-data-using-event-oids-5" tags: ["Endpoint Security (HX)", "Product Usage"] updated: 2026-09-23T17:25:03Z published: 2026-09-23T17:25:03Z canonical: "docs.trellix.com/retrieving-snmp-data-using-event-oids-5" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Retrieving SNMP data using event OIDs You can retrieve SNMP data using event object IDs (OIDs) after the MIB file has been downloaded. Prerequisites - Operator or Admin access - The MIB file must be downloaded. See [Downloading the MIB](/docs/downloading-the-mib-6). To retrieve SNMP data using event OIDs: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. SNMP is enabled by default. Verify that it is enabled: ``` hostname (config) # show snmp ``` If the output shows ` SNMP enabled: no`, enter the `snmp-server enable` command. 3. Enable the appliance to send notifications to the SNMP manager: ``` hostname (config) # snmp-server enable notify ``` 4. Specify the IP address of the SNMP manager: ``` hostname (config) # snmp-server host traps public ``` 5. Enable SNMP communities: ``` hostname (config) # snmp-server enable communities ``` 6. Add an SNMP community: ``` hostname (config) # snmp-server community ``` where `<community>` is the string needed by the SNMP server to query the appliance. The default community string is `public`. 7. Limit SNMP access to the listen interface called `ether1`: ``` hostname (config) # snmp-server listen interface ether1 ``` 8. Enable access to the listen interface: ``` hostname (config) # snmp-server listen enable ``` 9. Save your changes: ``` hostname (config) # write memory ``` :