--- title: "Upgrade to an IPv6 environment" slug: "upgrade-to-an-ipv6-environment" tags: ["ESM"] updated: 2026-09-12T21:25:11Z published: 2026-09-12T21:25:11Z canonical: "docs.trellix.com/upgrade-to-an-ipv6-environment" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Upgrade to an IPv6 environment 1. Copy the upgrade file to `/use/local/ess/update` or `/use/local/NitroGuard` to update each device (ESM, ERC, ACE, ELM, ELS, and ADM). 2. Reboot each device. 3. Modify the `/etc/NitroGuard/network.conf` file to configure the IPv6 address for each device. For ADM, modify the `/etc/rc.d/init.d/nitromode` file. 4. Reboot each device. 5. Re-key each device: - Use the IPv6 address format (https:///#/login) to open the Trellix ESM UI. - Navigate to Device Properties → Key Management → Key Device. - Click the back button and enter the IPv6 address of the device. - Click Next, enter the password, and then click Next. - Repeat these steps for the other devices. 6. For ADM, in the `/etc/rc.d/ini.d/nitromode` file find the line that starts with `MGT` and add the active state and full IPv6 address. There is no separate netmask, use the CIDR notation `::/prefixlength`. For example: ``` MGT[0]="yes;10.25.115.18;255.255.248.0;0.0.0.0 MGT[0]="yes;2607:8d40:42:3501:1111:ffff:ffff:1448/64" ``` 7. For ESM, complete the following: 1. Verify all brokers and seeds and so on have an IPv6 address in the `/etc/snowflex/snowflex.conf` file. 2. Add the IPv6 address to the `/etc/tomcat/conf/snowservice.conf` file. 3. Restart the service, or reboot. 8. For ERC, update the datasources with IPv6 addresses and roll out the changes. 9. For ACE, you have to manually update the datasources to IPv6: 1. In ESM, verify the current IP address of the datasources: ``` nquery -d esm -q 'select id, name, ipaddress from ips where ipsid in ()' ``` 2. If the IP address is IPv4, change it to IPv6: ``` nquery -d esm -q 'update ips set ipaddress="" where ipsid in ()' ``` 10. For ELM, complete the following: 1. If ELM storage was previously configured, update the IPv6 address of the storage server in the `/etc/NitroGuard/storage.conf` file. 2. Use the following commands to restart the service: ``` ELMStop ELMStart ``` 3. Add ELM to ERC. 11. For ELS, complete the following: 1. If ELS storage was previously configured, update the IPv6 address of the storage server in the `/etc/NitroGuard/storage.conf` file. 2. Use the following commands to restart the service: ``` ELSStop ELSStart ``` :