--- title: "Upgrading IPMI 3.11 and BIOS 1.9 firmware for specific platforms" slug: "upgrading-ipmi-3-11-and-bios-1-9-firmware-for-specific-platforms-1" tags: ["Endpoint Security (HX)", "Release Notes"] updated: 2026-09-10T22:23:57Z published: 2026-09-10T22:23:57Z canonical: "docs.trellix.com/upgrading-ipmi-3-11-and-bios-1-9-firmware-for-specific-platforms-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Upgrading IPMI 3.11 and BIOS 1.9 firmware for specific platforms The HX 4502 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. The AX 5550 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. **(COM-25469)** The CM 4500 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. **(COM-21016, COM-25601)** The EX 3500 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. **(COM-21016, COM-25601)** The NX 2550 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. **(COM-21016, COM-25601)** The VX 5500 model requires an upgrade to IPMI 3.11 and BIOS 1.9. You must install the IPMI upgrade before you upgrade the BIOS. **(COM-21016, COM-25601)** For detailed instructions about upgrading IPMI, see the *System Administration Guide*. To upgrade IPMI to version 3.11: ### Note IPMI network and password settings revert to factory defaults after this upgrade, and IPMI logs are deleted. Make a note of your settings and back up your IPMI logs. Do not shut down or remove power from the appliance during the upgrade. 1. Go to CLI configuration mode. hostname > `enable` hostname # `configure terminal` 2. Begin the upgrade: hostname (config) # `ipmi firmware update latest` 3. Confirm the upgrade: hostname (config) # `show ipmi` If the upgrade fails, try the steps again. If IPMI functions are not fully restored, perform a full power cycle (cold shutdown) on the appliance: 1. Stop the reload process: hostname (config) # `reload halt` 2. Disconnect all power cables for 2 minutes. 3. After 2 minutes, reconnect power cables and restart the appliance. To upgrade the BIOS to version 1.9: 1. Go to CLI configuration mode. hostname > `enable` hostname # `configure terminal` 2. Begin the upgrade: hostname (config) # `system bios firmware update latest` ### Note Do not shut down or remove power from the appliance during the upgrade. 3. Confirm the upgrade: hostname (config) # `show system bios` 4. Stop the reload process: hostname (config) # `reload halt` 5. Disconnect all power cables for 2 minutes. 6. After 2 minutes, reconnect power cables and restart the appliance. :