Use the CLI commands in this topic to upload HX appliance telemetry and statistics to the DTI cloud automatically every three hours. No customer-specific or proprietary information is exchanged.
Go to CLI configuration mode:
hostname > enable hostname # configure terminal
Set the automatic update schedule:
To update hourly, enter the following command, where
<mm>is the number of minutes within the hour when the update is triggered:fenet stats-content upload auto hourly at <mm>
To update daily, enter:
fenet stats-content upload auto daily at <hh>:<mm>where
<hh>:<mm>specifies the time to start the update based on a 24 hour clock.To update weekly, enter the following command, where
<day>is the day of the week the update should occur.fenet stats-content upload auto weekly on <day>To update monthly, enter the following command, where
<dd>is the day the update should occur:fenet stats-content upload auto monthly on <dd>To disable automatic updates, enter the following command:
fenet stats-content upload auto none
Validate the update configuration:
hostname (config) # show fenet stats-content status DTI Stats Content Status Information: Dynamic Threat Intelligence Service Enabled : yes Address : fenet1.fireeye.com Username : engtest Stats Content Uploads Enabled : yes Auto Upload Schedule : none (only rt-stats upload every 3 hours) Last Uploaded At : 2014/07/16 21:36:00 Status : Uploads done successfully: rt-stats Stats-content aggregators enabled (schedule): db-aggr no (default) dmesg-aggr no (default) pcaps-aggr no (default) rt-stats-aggr yes (default) Stats Aggregators Version: AGVR_00052 Run 'show fenet stats-content aggregator <aggr-name>' for further details.Save your changes.
hostname (config) # write memory