--- title: "2. Configure fail-open switch parameters" slug: "2-configure-fail-open-switch-parameters" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:39:53Z published: 2026-10-05T15:39:53Z canonical: "docs.trellix.com/2-configure-fail-open-switch-parameters" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 2. Configure fail-open switch parameters ## Before you begin To proceed with this setup you will require: - One DB9 RS-232 cable - One RJ-45 cable The steps below explain the configuration of parameters for your fail-open switch. ## Task 1. Connect the applicable cable to the fail-open switch. 2. Connect the other end to a computer which runs a terminal emulation software, such as HyperTerminal or PuTTY. 3. Launch the terminal emulation software, and set the communications parameters as shown below: - Baud rate: 19200 - Data bits: 8 - No parity - Stop bits: 1 - No flow control 4. Power up the fail-open switch. The CLI banner and login prompt are displayed. 5. At the login prompt, type the username and password, and press **Enter**. | For fail-open switch model 1 | | --- | | Username | Trellix | | Password | Trellix | The fail-open switch CLI prompt is displayed. 6. Use these commands for fail-open switch model 1. | Command | Description | | --- | --- | | set username <username> | Change the username of the fail-open switch. | | set password <password> | Change the password of the fail-open switch. | | set time <date & time> | Set the time and date of the fail-open switch in mm/dd/yyyy-hh:mm:ss. | | set ip <ip address> | Configures the IPv4 address of the fail-open switch. | | set mask <mask> | Configures the gateway IPv4 address to be used by the fail-open switch. | | set manager <ip address> | Configures the SNMP server IPv4 address. | | show display | View the state of the web interface. | | display | Enable or disable the Web Manager and management port of the fail-open switch. > [!NOTE] > Note > > The Web Manager enables you to view and manage all settings for a fail-open switch through a web console using administrator credentials. The management port enables you to establish communication between the fail-open switch and SNMP manager. You can enable or disable this view and the management port depending on your preferences. The default state is set to ON. | | show set | Displays the current settings for the fail-open switch. |