--- title: "2. Remove an active fail-open switch from the chassis" slug: "2-remove-an-active-fail-open-switch-from-the-chassis" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:40:36Z published: 2026-10-05T15:40:36Z canonical: "docs.trellix.com/2-remove-an-active-fail-open-switch-from-the-chassis" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 2. Remove an active fail-open switch from the chassis ## Before you begin You must make sure the fail-open switch is fully powered off before you attempt to remove it from the chassis. Follow the steps in this section to power off and remove the fail-open switch. ## Task 1. Power off the fail-open switch using the web interface or CLI command prompt. - If you are using the web interface, click the **Rescue** tab and check the **Power Off** checkbox in the **System Restore** section. To access the web interface, refer [Access the fail-open switch web interface](/network-and-platform/docs/access-the-fail-open-switch-web-interface). ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-B20138F3-1C48-4D58-81E2-9159A7B7E415-low.jpg?sv=2026-02-06&spr=https&st=2026-11-22T21%3A49%3A13Z&se=2026-11-22T22%3A49%3A13Z&sr=c&sp=r&sig=69riq%2FmLioVx2Q4nieMpv2PeJJv45yftE10%2FXJ01aQA%3D) - If you are using the CLI command prompt, type power_off and press **Enter**. To access the CLI command prompt, refer [3. Configure fail-open switch parameters_Silicom](/network-and-platform/docs/3-configure-fail-open-switch-parameters). 2. When the fail-open switch is powered off, remove the captive screws and slide it out of the chassis.