--- title: "3. Configure Active Fail-Open chassis parameters" slug: "3-configure-active-fail-open-chassis-parameters-5" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:35Z published: 2026-11-19T12:28:35Z canonical: "docs.trellix.com/3-configure-active-fail-open-chassis-parameters-5" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 3. Configure Active Fail-Open chassis parameters **Prerequisites:** To proceed with the setup, you require: - One RJ-45 RS-232 cable for console connection. - One RJ-45 cable for network management connection. Perform the following steps to configure the parameters of an Active Fail-Open chassis. 1. Connect the applicable cable to the 40G Active Fail-Open chassis. 2. Connect the RJ-45 RS232 cable to a computer which runs a terminal emulation software such as HyperTerminal or PuTTY. 3. Launch the terminal emulation software and set the following communication parameters: - Baud rate: 115200 - Data bits: 8 - No parity - Stop bits: 1 - No flow control 4. Turn on the Active Fail-Open chassis. The CLI banner and login prompt are displayed. 5. At the login prompt, type the username and password, and press **Enter**. **Username and password for both sets of Active Fail-Open modules** | For Active Fail-Open switches 12 thru 14 | | --- | | Username | `Trellix00` | | Password | `Trellix00` | The Active Fail-Open chassis CLI prompt is displayed. 6. Use the following commands for the Active Fail-Open modules 12 thru 14. **CLI commands for Active Fail-Open modules 12 thru 14** | Command | Description | | --- | --- | | `get_gateway` | Displays default gateway address. | | `get_ip` | Displays Active Fail-Open chassis IPv4 address. | | `get_netmask` | Displays Active Fail-Open chassis network mask. | | `set_gateway xxx.xxx.xxx.xxx` | Configures default gateway IPv4 address. Reboot the Active Fail-Open chassis for the new gateway IPv4 address to take effect. | | `set_ip xxx.xxx.xxx.xxx` | Configures Active Fail-Open chassis IPv4 address. Reboot the Active Fail-Open chassis for the new IPv4 address to take effect. | | `set_netmask xxx.xxx.xxx.xxx` | Configures Active Fail-Open chassis network mask. Reboot the Active Fail-Open chassis for the new network mask to take effect. | | `get_stat` | Displays the device statistics | | `stop_all_sessions` | Stops all opened sessions | For more information on the CLI commands, see Trellix Intrusion Prevention System 10G/40G Active Fail-Open Bypass Kit Guide.