--- title: "3. Configure Active Fail-Open chassis parameters" slug: "3-configure-active-fail-open-chassis-parameters-7" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:59Z published: 2026-11-19T12:30:59Z canonical: "docs.trellix.com/3-configure-active-fail-open-chassis-parameters-7" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 3. Configure Active Fail-Open chassis parameters **Prerequisites:** To proceed with the setup, you will require: - One RJ-45 RS-232 cable for console connection. - One RJ-45 cable for network management connection. Perform the following steps to configure the parameters of an Active Fail-Open chassis. 1. Connect the applicable cable to the Active Fail-Open chassis. 2. Connect the RJ-45 RS232 cable to a computer which runs a terminal emulation software such as HyperTerminal or PuTTY. 3. Launch the terminal emulation software and set the following communication parameters: - Baud rate: 115200 - Data bits: 8 - No parity - Stop bits: 1 - No flow control 4. Turn on the Active Fail-Open chassis. The CLI banner and login prompt are displayed. 5. At the login prompt, type the username and password, and press **Enter**. **Username and password for both sets of Active Fail-Open modules** | For Active Fail-Open switches 16 and 17 | | --- | | Username | `Trellix00` | | Password | `Trellix00` | The Active Fail-Open chassis CLI prompt is displayed. 6. Type the following commands for the Active Fail-Open modules 28 and 29. - `enable` - `configure` - `management eth-if ip x.x.x.x` - `management eth-if ip-mask y.y.y.y` - `management eth-if default-gateway z.z.z.z` - `write memory` > [!NOTE] > Note > > Reboot of the system is not required. For more information on the CLI commands, see Trellix Intrusion Prevention System 100 Gigabit Modular Active Fail Open Bypass Kit Guide.