---
title: "3. Configure Active Fail-Open chassis parameters"
slug: "3-configure-active-fail-open-chassis-parameters"
tags: ["Product Usage", "IPS 10.1.10"]
updated: 2026-10-05T15:41:11Z
published: 2026-10-05T15:41:11Z
canonical: "docs.trellix.com/3-configure-active-fail-open-chassis-parameters"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# 3. Configure Active Fail-Open chassis parameters
## Before you begin
To proceed with the setup, you require:
- One RJ-45 RS-232 cable for console connection.
- One RJ-45 cable for network management connection.
Perform the following steps to configure the parameters of an Active Fail-Open chassis.
## Task
1. Connect the applicable cable to the 40G Active Fail-Open chassis.
2. Connect the RJ-45 RS232 cable to a computer which runs a terminal emulation software such as HyperTerminal or PuTTY.
3. Launch the terminal emulation software and set the following communication parameters:
- Baud rate: 115200
- Data bits: 8
- No parity
- Stop bits: 1
- No flow control
4. Turn on the Active Fail-Open chassis.
The CLI banner and login prompt are displayed.
5. At the login prompt, type the username and password, and press
**Enter**.
| For Active Fail-Open switches 12 thru 14 |
| --- |
| Username | Trellix00 |
| Password | Trellix00 |
The Active Fail-Open chassis CLI prompt is displayed.
6. Use the following commands for the Active Fail-Open modules 12 thru 14.
| Command | Description |
| --- | --- |
| get_gateway | Displays default gateway address. |
| get_ip | Displays Active Fail-Open chassis IPv4 address. |
| get_netmask | Displays Active Fail-Open chassis network mask. |
| set_gateway xxx.xxx.xxx.xxx | Configures default gateway IPv4 address. Reboot the Active Fail-Open chassis for the new gateway IPv4 address to take effect. |
| set_ip xxx.xxx.xxx.xxx | Configures Active Fail-Open chassis IPv4 address. Reboot the Active Fail-Open chassis for the new IPv4 address to take effect. |
| set_netmask xxx.xxx.xxx.xxx | Configures Active Fail-Open chassis network mask. Reboot the Active Fail-Open chassis for the new network mask to take effect. |
| get_stat | Displays the device statistics |
| stop_all_sessions | Stops all opened sessions |
For more information on the CLI commands, see Trellix Intrusion Prevention System 10G/40G Active Fail-Open Bypass Kit Guide.