4. Configure notification by SNMP traps

Prev Next

Before you begin

  • To configure SNMP traps, you require a server that acts as an SNMP server. The SNMP server can be any Windows or Linux system installed with a MIB browser such as iReasoning.

    To view the requirements and download a copy of iReasoning MIB browser, follow the link: https://ireasoning.com/mibbrowser.html.

  • Make sure the IP address of the 100G Active Fail-Open chassis can be reached within the network.
  • Make sure the SNMP server and the 100G Active Fail-Open chassis are able to communicate.
  • In addition, you need to obtain MIB files to decode alert codes sent by the 100G Active Fail-Open modules. This file can be obtained from the Web Interface → SNMP → Mib File.

Task

  1. Connect an RJ-45 cable to the management port at the front of the 100G Active Fail-Open chassis.
  2. Connect the other end to a network device so that the SNMP server is reachable through the network.
  3. Copy the MIB files of an Active Fail-Open module to a suitable location on the SNMP server.
    For example, an SNMP trap is generated when one of the following events occur:
    • Bypass state changes
    • Any of the port link status changes
    • Either power supply state changes or some other trap defined under SNMP → Trap Filter in the web interface.
  4. Set up the 100G Active Fail-Open chassis IP address, network mask, and SNMP manager IP address using the commands provided in the section Active Fail-Open.
  5. Make sure the SNMP manager and Active Fail-Open chassis are able to communicate.

Results

Configuration of SNMP traps is complete when a trap appears in the MIB browser.