--- title: "4. Configure notification by SNMP traps" slug: "4-configure-notification-by-snmp-traps-5" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:35Z published: 2026-11-19T12:28:35Z canonical: "docs.trellix.com/4-configure-notification-by-snmp-traps-5" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 4. Configure notification by SNMP traps **Prerequisites:** - To configure SNMP traps, you require a server that acts as an SNMP server. The SNMP server can be any Windows or Linux system installed with a MIB browser such as iReasoning. To view the requirements and download a copy of iReasoning MIB browser, follow the link: [https://ireasoning.com/mibbrowser.html](https://ireasoning.com/mibbrowser.html). - Make sure the IP address of the 40G Active Fail-Open chassis can be reached within the network. - Make sure the SNMP server and the 40G Active Fail-Open chassis are able to communicate. - In addition, you need to obtain MIB files to decode alert codes sent by the 10G/40G Active Fail-Open modules. These files are specific to the 10G/40G Active Fail-Open modules and can be obtained by clicking this link: [KB86247](https://support.trellix.com/s/article/KB86247). **Steps:** 1. Connect an RJ-45 cable to the Management port at the front of the 40G Active Fail-Open chassis. 2. Connect the other end to a network device so that the SNMP server is reachable through the network. 3. Copy the MIB files of an Active Fail-Open module to a suitable location on the SNMP server. For example, an SNMP trap is generated when one of the following events occur: - Bypass state changes - Any of the port link status changes - Either power supply state changes or any other trap defined under **Snmp** → **SNMP trap control** in the web interface. 4. Set up the 40G Active Fail-Open chassis IP address, network mask, and SNMP manager IP address using the commands provided in the section [3. Configure Active Fail-Open chassis parameters](/network-and-platform/docs/3-configure-active-fail-open-chassis-parameters-5). 5. Make sure the SNMP manager and Active Fail-Open chassis are able to communicate. Configuration of SNMP traps is complete when a trap appears in the MIB browser.