--- title: "4. (Optional) Configure notification by SNMP traps" slug: "4-optional-configure-notification-by-snmp-traps-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:51Z published: 2026-11-19T12:30:51Z canonical: "docs.trellix.com/4-optional-configure-notification-by-snmp-traps-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 4. (Optional) Configure notification by SNMP traps **Prerequisites:** - To configure SNMP traps, you will require a server that acts as an SNMP server. The SNMP server can be any Windows or Linux system installed with a MIB browser, such as iReasoning. To view requirements and download a copy of iReasoning MIB browser, follow the link:[https://ireasoning.com/mibbrowser.html](https://ireasoning.com/mibbrowser.html). - Make sure your fail-open switch IP address can be reached within the network. - Make sure your SNMP server and fail-open switch are able to communicate. - In addition, you will need to obtain MIB files to decode alert codes sent by the fail-open switch. These files are specific to the fail-open switch and can be obtained by clicking this link: [KB86247](https://support.trellix.com/s/article/KB86247). - You will require the RJ-45 cable. 1. Connect an RJ-45 cable to the Management Port at the front of the fail-open switch. 2. Connect the other end to a network device so that the SNMP server is reachable through the network. 3. Copy the fail-open switch MIB files to a suitable location on the SNMP server. For example, an SNMP trap is generated when one of the following events occur: - Bypass state changes - Any port link status changes - Either power supply state changes 4. Set up the fail-open switch IP address, network mask, and SNMP manager IP address using the commands provided in the section Configure the fail-open switch parameters. 5. Make sure the SNMP manager and fail-open switch are able to communicate. Configuration of SNMP traps is complete when you can see a trap appear in the MIB browser.