--- title: "5. Deploy a Sensor in inline Active Fail-Open mode" slug: "5-deploy-a-sensor-in-inline-active-fail-open-mode-1" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:31Z published: 2026-11-19T12:29:31Z canonical: "docs.trellix.com/5-deploy-a-sensor-in-inline-active-fail-open-mode-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 5. Deploy a Sensor in inline Active Fail-Open mode **Prerequisites:** - The Sensor must be set up and have established trust with a Manager server. - The Sensor has a free port pair which can be deployed in inline Active Fail-Open mode. - It is assumed that you have inserted necessary transceiver modules into the Sensor if you have completed cabling the Sensor and Active Fail-Open module. To configure a fail-open switch you must configure the port pair to operate as an inline fail-open port. 1. After cabling the Sensor and the fail-open switch, log on to your Manager. 2. Go to **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 3. Double-click port one of the configurable ports, say **2/1** (Gx/1). A configuration panel appears on the right side of the window. 4. Click the **State** drop-down and select **Enabled**. This will impact the port 2/2 (Gx/2) as well. So, ports **2/1-2/2** (Gx/1-Gx/2) are enabled. 5. Click the **Certification** drop-down and select an option depending on your requirement. > [!NOTE] > Note > > Based on the I/O module and port selected, you may be required to select the **Auto Negotiate** checkbox and set the speed under **Maximum Negotiable Speed (Duplex)**. For certain ports, the speed is automatically selected and you will not be able to edit it. 6. Click the **Mode** drop-down and select **Inline Fail Open – Active**. This means port pair 2/1-2/2 is now configured for inline fail-open. 7. Under **Placement**, select **Inside Network** or **Outside Network** from the drop-down list, depending on how you want to configure your ports. **Placement** refers to the area of the network which that individual port is connected. **Configuration of a port pair for inline fail-open active operation**![Configuration of a port pair for inline fail-open active operation](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-925efce8-4b5d-4d90-eeb2-cb3684edb961(7).png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A40%3A50Z&se=2026-11-20T14%3A40%3A50Z&sr=c&sp=r&sig=1QQ4jX6e5WhNziCSutQXbwdMJ%2BzaHxg%2BGpV9%2BKSD2tk%3D) 8. Click **Save**. > [!NOTE] > Note > > An **Alert!** pop-up displays stating the changes made on port x/1 impacts x/2 as well. Click **OK**. If traffic is passing through the ports, you will notice the port link status changes to **Up** and goes green.