--- title: "6. Deploy a Sensor in inline fail-open mode" slug: "6-deploy-a-sensor-in-inline-fail-open-mode" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:40:36Z published: 2026-10-05T15:40:36Z canonical: "docs.trellix.com/6-deploy-a-sensor-in-inline-fail-open-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # 6. Deploy a Sensor in inline fail-open mode ## Before you begin A Sensor which - Is set up and has established trust with a Manager - Has a free port pair that can be deployed in inline fail-open configuration - SFPs or XFPs, depending on the Sensor model and fail-open switch model > [!NOTE] > Note > > The steps below assume you are using an M-Series Sensor when selecting ports. Configuration of a port pair for inline fail-open active operation ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-FC233FEE-DAC4-4D4A-AAA7-BB7BC90F44F1-low.png?sv=2026-02-06&spr=https&st=2026-11-22T21%3A11%3A06Z&se=2026-11-22T22%3A11%3A06Z&sr=c&sp=r&sig=waujYdFVvuIf%2F1c1UW4Gy7%2FZ6eAEjbhSGR962Z5Lwl4%3D) To configure a fail-open switch you must configure the port pair to operate as an inline fail-open port. ## Task 1. After cabling the Sensor and the fail-open switch, log on to your Manager. 2. Go to **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 3. Double-click port **1A**. A configuration window appears on the right side of the page. 4. Click the **State** drop-down and select **Enabled**. This enables port **1A-1B**. 5. Select the **Auto Negotiate** checkbox and make sure the **Speed (Duplex)** is set to **1 Gbps (Full)**. 6. Click the **Mode** drop-down and select **Inline Fail Open**. This means port pair 1A-1B is now configured for inline fail-open. 7. Click the **Placement** drop-down and select **Inside Network** or **Outside Network**, depending on how you want to configure your ports. **Placement** refers to the area of the network which that individual port is connected. 8. Click the **Response Port** drop-down and select the right port that you want to assign. For an inline fail-open or fail-closed setup, you can configure the same port to be the response port. 9. Click **Save**. ## Results If traffic is passing through the ports, you will notice the port link status changes to **Up** and goes green.