--- title: "About Sensor port configuration" slug: "about-sensor-port-configuration-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:35Z published: 2026-11-19T12:28:35Z canonical: "docs.trellix.com/about-sensor-port-configuration-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # About Sensor port configuration Before you configure the Sensor ports, you must have installed the Sensor and added to the Manager interface. **Configure inline mode for a single Sensor** This section contains recommendations for deploying a single Sensor in inline mode. > [!NOTE] > Note > > Configuration for a fail-open kit is described in the fail-open kit documentation. For example, to configure the Sensor to work with the copper fail-open kit, see the Trellix Intrusion Prevention System Fail-Open Kit Product Guide. 1. In the Manager interface, select **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. 2. Double-click on a numbered port (for example, 3/1) from **Monitoring Ports**. **Monitoring Port Details** panel displays current port settings. **Verifying ports for inline fail-open mode**![Verifying ports for inline fail-open mode](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-1d9cb0e5-e770-dc4d-3e81-19788d55f0a9(7).png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A54%3A35Z&se=2026-11-20T12%3A54%3A35Z&sr=c&sp=r&sig=91AeeAbRZEN4MWwP36JMj0NAy7gGtNKWwMI1m0N%2FItM%3D) 3. Set the Administrative **State** to **Disable** (off). 4. Select the other port (for example, 3/2) and set the Administrative **State** to **Disable** (off). 5. Now select the aforesaid port (port 3/1) and select the **Auto Negotiate** checkbox. 6. Select the port **Speed**. 7. Do one of the following: - For inline fail-closed operation, select **Inline Fail Closed** as the operating Mode. - For inline fail-open operation, select **Inline Fail Open** or **Inline Fail Open - Active** as the operating Mode. Confirm (**Yes**) that you have already connected a fail-open kit. However, if your Sensor supports in-built fail-open on that port, you might not require a fail-open kit. > [!NOTE] > Note > > **Inline Fail Open** indicates in-built passive fail-open which is supported on different Sensors differently. 8. Select the area of your network to which the current port is connected: **Inside** (traffic generated internally, destined for the external network) or **Outside** (traffic generated externally, destined for the internal network). 9. Set the Administrative **State** to **Enable** (on). 10. Click **Save**. 11. Repeat for any other ports you need to configure. 12. Download the changes to your Sensor by clicking the **Deploy Pending Changes** option.