Links between Sensor and Active Fail-Open module Mon0/Mon1 are up but the Sensor is not receiving any traffic from the Active Fail-Open module. When this occurs, the BYP/TAP/DISC LED is Amber and INLINE LED is OFF.
You can troubleshoot the issue using the following two methods:
At the CLI, run the following commands:
get_hb_act_mode- IfHB active modeisoff, enter the next command.get_bypass_mode- IfActive stateisbypass, enter the next command.set_hb_act_mode on
From the web interface:
Check if the Active State is in Inline or Bypass or Tap.
.png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A56%3A54Z&se=2026-11-20T14%3A07%3A54Z&sr=c&sp=r&sig=JFs9rhrUxnfun%2BWHmCGdF0L6RNlbwQj58RLi7UtDEi8%3D)
Check if the Appl State is unknown. This means that the module in forced bypass state.
In the Bypass page, confirm that HB active mode is set to ON.
.png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A56%3A54Z&se=2026-11-20T14%3A07%3A54Z&sr=c&sp=r&sig=JFs9rhrUxnfun%2BWHmCGdF0L6RNlbwQj58RLi7UtDEi8%3D)