--- title: "Add a RADIUS server" slug: "add-a-radius-server-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:27:57Z published: 2026-11-19T12:27:57Z canonical: "docs.trellix.com/add-a-radius-server-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Add a RADIUS server To add the RADIUS server configuration in Manager, do the following: **Steps:** 1. Select **Manager** → **** → **Setup** → **GUI Access** → **RADIUS Authentication**. > [!NOTE] > Note > > To add a RADIUS server in the Central Manager, select **Manager** → **Setup** → **GUI Access** → **RADIUS Authentication**. 2. Click ![GUID-A6ACF06E-8B7C-4F33-9335-99E4B1FDEB3D-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-a265d0b5-4039-16f5-7bb1-cb4512697e13(8).png?sv=2026-02-06&spr=https&st=2026-11-20T12%3A00%3A33Z&se=2026-11-20T13%3A00%3A33Z&sr=c&sp=r&sig=16CNV5so6kladiev0cqXq3VJdcyBGisq1DaMZ5aL%2B80%3D). The **Add a RADIUS Server** page is displayed. 3. Select **Yes** next to **Enable RADIUS Authentication?**. 4. Type the **RADIUS Server Name or IP Address** (IPv4 or IPv6 address). > [!WARNING] > Caution > > Only use a valid server name, since Trellix IPS does not check to see if the names are valid. A valid server name is the name of the host on which RADIUS server is configured. Type the RADIUS **Server Port**. The port number should be between 0 and 65535. (default =1812). 5. Type a **Shared Secret Key** that is required on both the Manager and the RADIUS server. The Shared Secret key is same as entered in the RADIUS server during configuration. 6. Select the **Connection Time Out** (in milliseconds). This time determines how long the Manager should wait for authentication. Three attempts are made to connect before timeout occurs, so the value you enter is how long Trellix IPS waits between attempts before timeout (default =6000 milliseconds). 7. (Optional) Click **Test Connection** to verify that the Manager can connect to the RADIUS server. > [!NOTE] > Note > > If Manager Disaster Recovery (MDR) is enabled, both the Primary and Secondary Manager IP addresses must be registered in the RADIUS server. 8. Click **Save** to save your changes. > [!NOTE] > Note > > If RADIUS servers are configured with Central Manager, and the RADIUS servers exist in private networks and Managers exist in public network, the RADIUS configuration needs to be customized at Manager in a way that it reaches the RADIUS Server through translated public IP address.