--- title: "Adding a destination to the data exfiltration whitelist using the CLI" slug: "adding-a-destination-to-the-data-exfiltration-whitelist-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:05Z published: 2026-09-02T17:27:05Z canonical: "docs.trellix.com/adding-a-destination-to-the-data-exfiltration-whitelist-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding a destination to the data exfiltration whitelist using the CLI Use the `smartvision exfil whitelist <ipAddress>/<prefix>` command to add a destination IPv4 address range to the data exfiltration alerts whitelist. The data exfiltration whitelist specifies *destination addresses* only. The appliance does not generate data exfiltration alerts for data uploads to hosts or networks in the data exfiltration whitelist. The data exfiltration whitelist is empty by default. ### Prerequisites - Admin access to the SmartVision appliance. To add a destination to the data exfiltration whitelist: 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. To add an internal IPv4 address range to the whitelist, enter the following command. ``` smartvision exfil whitelist / ``` This example adds an IPv4 address range to the whitelist and verifies the configuration change: ``` hostname (config) # smartvision exfil whitelist 192.168.0.0/24 hostname (config) # show smartvision config SmartVision Config              .              .              .        Data exfil detection whitelist network:                 192.168.0.0/24              .              .              . ``` 3. Save your changes. ``` hostname (config) #  write memory ``` :