--- title: "Adding an appliance in a NAT deployment using the Central Management System CLI" slug: "adding-an-appliance-in-a-nat-deployment-using-the-central-management-system-cli-3" updated: 2026-09-30T16:07:50Z published: 2026-09-30T16:07:50Z canonical: "docs.trellix.com/adding-an-appliance-in-a-nat-deployment-using-the-central-management-system-cli-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding an appliance in a NAT deployment using the Central Management System CLI Use the commands in this section to add an appliance that is behind a NAT gateway to the Central Management System appliance. ### Note The procedure in this section includes the basic steps for adding an appliance. Additional options are available. See the *CLI Command Reference* for a full list of the` cmc `commands and details about their parameters and usage. To add an appliance: 1. Log in to the Central Management System CLI. 2. Go to CLI configuration mode: ```plaintext cm-hostname > enable cm-hostname # configure terminal ``` 3. Specify the virtual NAT IP address that is mapped to the appliance internal IP address: ```plaintext cm-hostname (config) # cmc appliance address ``` where` applianceID `is the appliance record name. ### Important Specify the IP address, not the hostname. Otherwise, if the hostname changes later, the connection will be broken and the appliance will need to be added again. 4. (Optional) Specify the virtual NAT port that is mapped to the appliance internal SSH port: ```plaintext cm-hostname (config) # cmc appliance port ``` The port defaults to 22 if it is not specified. 5. Configure authentication: ```plaintext cm-hostname (config) # cmc appliance authtype cm-hostname (config) # cmc appliance auth username cm-hostname (config) # cmc appliance auth password | identity ``` where` authtype `can be` password`,` ssh-dsa2`, or` ssh-rsa-2`. (See [Configuring User Authentication Using the CLI](/network-and-platform/docs/configuring-user-authentication-using-the-cli-3) for details.) 6. (Optional) Add a comment describing the appliance: ```plaintext cm-hostname (config) # cmc appliance comment ``` 7. Save your changes: ```plaintext cm-hostname (config) # write memory ``` ### Example The following example adds Acme-NX to the Central Management System appliance and configures password authentication. ```plaintext cm-hostname (config) # cmc appliance Acme-NX address 10.3.3.6 cm-hostname (config) # cmc appliance Acme-NX port 1000 cm-hostname (config) # cmc appliance Acme-NX authtype password cm-hostname (config) # cmc appliance Acme-NX password username admin3 cm-hostname (config) # cmc appliance Acme-NX password password 12345abcde cm-hostname (config) # cmc appliance Acme-NX comment New York NX Series ``` :