--- title: "Adding an entry to the SmartVision alerts whitelist using the Web UI" slug: "adding-an-entry-to-the-smartvision-alerts-whitelist-using-the-web-ui" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:05Z published: 2026-09-02T17:27:05Z canonical: "docs.trellix.com/adding-an-entry-to-the-smartvision-alerts-whitelist-using-the-web-ui" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding an entry to the SmartVision alerts whitelist using the Web UI If alerts are triggered by valid traffic, you can use the Add Whitelist Combination dialog box to add a combination of conditions for whitelisting SmartVision alerts. ![Settings_SmartVision_Whitelist_add.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-741c59bc-b2b1-780d-d48c-83499909ac8d.png?sv=2026-02-06&spr=https&st=2026-11-20T06%3A20%3A23Z&se=2026-11-20T07%3A20%3A23Z&sr=c&sp=r&sig=gj%2BPAuBVvEPeYjcLcFajWjM%2BAwULMFfDyG22QDCt1e8%3D) If a SmartVision event matches all conditions specified by any entry in the whitelist, the appliance does not generate an alert for that event. Each entry in the whitelist specifies one or more of the following conditions: **Rule ID** To eliminate false-positive alerts triggered by a particular SmartVision rule, specify the rule ID. **Source IP / Mask** To eliminate false-positive alerts triggered by traffic sent from a particular network host or range of IP addresses, specify the IPv4 or IPv6 source address in classless inter-domain routing CIDR format (`<ipAddress>/<prefix>`). **Destination IP / Mask** To eliminate false-positive alerts triggered by traffic sent to a particular network host or range of IP addresses, specify the IPv4 or IPv6 source address in CIDR format. ### Prerequisites - Admin access to the SmartVision appliance. - SmartVision is enabled. To add a combination of alert whitelisting criteria: 1. Log in to the appliance Web UI and select **Settings > SmartVision Configuration**. 2. Click **SmartVision Alerts Configuration**. 3. Go to the SmartVision Alerts Whitelist panel and click **Add**. 4. Specify one or more of the following conditions: - Rule ID - Source IP/Mask - Destination IP/Mask 5. Click **Save**. :