--- title: "Adding hosts to the home network using the CLI" slug: "adding-hosts-to-the-home-network-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:09Z published: 2026-09-02T17:27:09Z canonical: "docs.trellix.com/adding-hosts-to-the-home-network-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding hosts to the home network using the CLI Follow these steps to add IP addresses to the data exfiltration detection home network list. When data exfiltration detection is enabled, the appliance monitors the egress traffic from the hosts specified in the home network list. The list is empty by default. ### Important After you configure or edit the homenet list, it takes 72 hours to build baseline egress traffic profiles for the specified hosts and networks. ### Prerequisites - Admin access to the SmartVision appliance. To add an IP address range to the data exfiltration detection homenet list: 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Add a range of IP addresses to the data exfiltration detection homenet list by using the following command. Specify an IPv4 address range in classless inter-domain routing (CIDR) format. ``` smartvision exfil homenet / ``` The following the example, hosts with IP addresses from 10.13.65.0 through 10.13.65.255 are added to the list of hosts monitored for data exfiltration activity: ``` hostname (config) # smartvision exfil homenet 10.13.65.0/24 ``` 3. Verify your configuration change. ``` hostname (config) # show smartvision config SmartVision Config              .              .              .        Data exfil detection customer networks:                10.13.65.0/24              .              .              . ``` 4. Save your changes. ``` hostname (config) #  write memory ``` :