--- title: "Adding or deleting a TCP port for SSL interception using the CLI" slug: "adding-or-deleting-a-tcp-port-for-ssl-interception-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:40Z published: 2026-09-12T20:42:40Z canonical: "docs.trellix.com/adding-or-deleting-a-tcp-port-for-ssl-interception-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding or deleting a TCP port for SSL interception using the CLI Use the commands in this section to add a TCP port or to delete a TCP port for SSL interception. You can specify a maximum of 8 TCP ports for SSL interception. **To add a TCP port:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Specify the TCP port to intercept HTTPS traffic. ``` hostname (config) # policymgr ssl-intercept config tcp port ``` where `<port_number>` is the TCP port number. 3. Repeat the previous step for each port you want to add. 4. Save your changes. ``` hostname (config) # write memory ``` **To delete a TCP port:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Specify the TCP port to delete. ``` hostname (config) # no policymgr ssl-intercept config tcp port ``` where `<port_number>` is the TCP port number. 3. Repeat the previous step for each port you want to delete. 4. Save your changes. ``` hostname (config) # write memory ```