Adding or removing a comment using the CLI

Use the commands in this section to add or remove a comment for an HA pair.

To add a comment:

Enable the CLI configuration mode:

hostname > enable
hostname # configure terminal

Add the comment:
```
hostname (config) # cmc ha nx <pair> comment <"comment">
```
where <pair> is the name of the HA pair, and <"comment"> is the description (enclosed in double quotation marks).
Save your change:
```
hostname (config) # write memory
```

To remove a comment:

Enable the CLI configuration mode:

hostname > enable
hostname # configure terminal
hostname (config) #

Remove the comment:
```
hostname (config) # cmc ha nx <pair> comment ""
```
where <pair> is the name of the HA pair, and the double quotation marks indicate an empty string.

Examples

The following example adds "Western region NX pair" as a comment that describes the Acme_NXHA pair.

hostname (config) # cmc ha nx Acme_NXHA comment "Western region NX pair"
hostname (config) # show cmc ha nx Acme_NXHA
NX-HA Acme_NXHA nx-1 nx-2        Status: OK
    Comment:                            Western region NX pair
    Connected:                          yes
    ...

The following example removes the comment by replacing it with an empty string.

hostname (config) # cmc ha nx Acme_NXHA comment ""
hostname (config) # show cmc ha nx Acme_NXHA
NX-HA Acme_NXHA nx-1 nx-2        Status: OK
    Comment:
    Connected:                   yes
    ...